This action replaces a robot with a different robot model while keeping the rest of the station intact. The new robot is placed under the same reference frame, the tools of the old robot are moved onto the new one, and every target, program and machining project that referenced the old robot is re-linked to the new one and recalculated.
Note: If the new robot has a different base height, RoboDK measures the difference and offsets the robot base frame to compensate. That base frame is also renamed to the name used by the replacement robot, which keeps the Set Reference Frame instructions inside your programs valid.
Important: Cartesian targets keep their position and orientation, but their stored robot configuration is solved again using the tool that is active at that moment, so a target can come back with a different arm configuration. Joint targets are not solved again at all — their joint values are carried over as they are. Targets that the new robot cannot reach are reported in the RoboDK message log rather than in a pop-up, so always re-validate your programs after a swap.