Setup

This example uses the Motoman MH50-35 robot, a laser cutting head, a stamped piece of metal and a laser cutting table.

Load the station:

1.Select File➔Example Laser Cutting - Image 1 Open

2.Locate the Laser-Cutting example from RoboDK’s examples section:      
C:/RoboDK/Examples/Plugin-Fusion-360-Laser-Cutting.rdk.

Note that the Example Laser Cutting - Image 2 reference frame called “Part” in the middle of the table is where the part will be imported. Make sure that this reference frame is activated by right clicking on Example Laser Cutting - Image 3 Reference Frame➔Active Reference Frame.

Example Laser Cutting - Image 4

Now that you have loaded the station you can open Fusion 360.