Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fusion 360 with RoboDk offset problem

In Fusion 360 CNC simulation works fine. When I send the data to RoboDk the top of my holes are at the fixture surface face and then drill thru the fixture not thru the part. Where do I change to make the top of my fixture the bottom of my part.
Could you share your Fusion 360 project and the RoboDK project?

These are the f3d and rdk files respectively.
Unable to upload f3d files. Forum software does not allow

Users browsing this thread:
1 Guest(s)