7 hours ago
Hi RoboDK Support Team,
I’m having trouble using the Attach command. The object does not attach to the tool and stays in place during the simulation.
Could you tell me what possible causes I should check?
The tool and object seem properly aligned, and the command is being called in the program, but it still does not work.
Any advice would be appreciated.
Best regards,
Keisuke Sakai
I’m having trouble using the Attach command. The object does not attach to the tool and stays in place during the simulation.
Could you tell me what possible causes I should check?
The tool and object seem properly aligned, and the command is being called in the program, but it still does not work.
Any advice would be appreciated.
Best regards,
Keisuke Sakai