Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Kawasaki welding post-processor

#1
Hello,

Is there Kawasaki post-processor what support the Kawasaki welding sepcific AS codes?
Eg.: LWS = Linear Weld Start; LWC = Linear Weld Continuous; LWE= Linear Weld End


Best Regards,

Tibi
#2
Yes, weld movements are supported with Kawasaki robot controllers.

You should trigger the start and end of a weld path using ArcStart/WeldStart and ArcEnd/WeldEnd respectively.
#3
(02-01-2023, 09:06 PM)Albert Wrote: Yes, weld movements are supported with Kawasaki robot controllers.

You should trigger the start and end of a weld path using ArcStart/WeldStart and ArcEnd/WeldEnd respectively.

Thanks Albert,

It's looks good.

Tibi
  




Users browsing this thread:
2 Guest(s)