RoboDK Forum > RoboDK (EN) > General questions about RoboDK > Post processor for Sinumerik 840D sl and Comau
RoboDK Forum > RoboDK (EN) > General questions about RoboDK > Post processor for Sinumerik 840D sl and Comau

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Post processor for Sinumerik 840D sl and Comau

cotega Offline
Junior Member
*
Posts: 3
Threads: 3
Joined: Jan 2023
Reputation: 0
#1
09-21-2023, 07:07 PM (This post was last modified: 09-22-2023, 10:41 AM by Albert.)
Hi, I would like to know if there is a post processor available in RoboDK for a Comau Robot controlled with Sinumerik 840D sl Run MyRobot. ( SINUMERIK Run MyRobot /Direct Control - PLC - ID: 109758486 - Industry Support Siemens ).


Thank you,
Find
Reply
Albert Offline
Moderator
*****
Posts: 3,458
Threads: 2
Joined: Apr 2018
Reputation: 165
#2
09-22-2023, 10:33 AM
Yes, RoboDK supports the Sinumerik 840D controller and Comau robots well.

Once you install RoboDK and create a simulation you'll find these 2 post processors:
  1. Siemens Sinumerik: exports coordinates in mm.
  2. Siemens Sinumerik Inch: Exports coordinates in inch.
Find
Reply
  




Users browsing this thread:
1 Guest(s)