[Bfish276]

Hello, right now I am struggling with getting the programs made in RoboDK to run on my Staubli CS8C controller. It's running S6 so that's what I set the post processor to but I am getting parameter faults with the code regarding the tooling. If you had any suggestions that would be greatly appreciated.

[Albert]

Can you share the RoboDK project you are using and the error code/message you obtain when you run the program on the real robot controller?

Have you tried a different post processor meant for more recent Staubli robot controllers? For example the Staubli VAL3 post processor.

[Bfish276]

Hello Albert, while I was reloading the program it seems to work fine now. I am not sure what the problem was before, but it seems to be working fine now. I appreciate you reaching out though!

[Albert]

Thank you for letting us know.