[ghazali aziz]

hi all ,

I am using a meca500 R3 with roboDk , bu i'm unable to send the program to the robot and execute it.
the connection between the computer and the robot is good.
This is the error message i recevie when attempting to do so.

thanks

[Albert]

Do you see any error messages after entering the program number and selecting OK?

[ghazali aziz]

Do you see any error messages after entering the program number and selecting OK?

this is the error that i see .

---

Do you see any error messages after entering the program number and selecting OK?

this is the error that i see .

the robot seems connected to robodk

---

Do you see any error messages after entering the program number and selecting OK?

this is the error that i see .

---

Do you see any error messages after entering the program number and selecting OK?

this is the error that i see .

the robot seems connected to robodk

[Albert]

There seems to be a problem when saving your program files on your computer. I recommend you to save your programs somewhere outside of the OneDrive folder. To specify where to save your program files you can follow one of these 2 procedures:

• You can right click on the program and select Save Program as...
  
• You can specify the folder to save programs in Tools-Options-Program tab, where you can set the Robot Programs folder
  

[ghazali aziz]

Thanks a lot, it works as you said.

Thank you very much.

[Albert]

Thank you for your feedback.