Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Universal Robot Programs


I created a program in Robodk and tested it by hitting the "Run on Robot" and everything ran fine. but when i try to run it from polyscope the positions are not where they should be. could it be from the installation file thats loaded in polyscope? or would it be caused from a tcp issue? thanks
Hi Jacob,

I hope you are fine.
Can you tell me what post-processor you are using?
Universal Robots
Universal Robots URP


Users browsing this thread:
2 Guest(s)