[amartinmestres]

Hello, we have a 3D printing project in which we want the part to be printed by two robots, each one has half of the part. There are areas that if the two claws were printed at the same time have a collision, is there a way to avoid these collisions, or at least to indicate which points may collide?

Thanks

[Olivier]

Hi amartinmestres,

You activate the collision check and modify the collision map by clicking on the icon as shown in the picture. 

Olivier

[Jeremy]

Take a look at this link from our documentation:
https://robodk.com/doc/en/Collision-Avoi...Collisions

Jeremy