RoboDK Forum > RoboDK (EN) > General questions about RoboDK > Define a Frame from actual Robot Joints
RoboDK Forum > RoboDK (EN) > General questions about RoboDK > Define a Frame from actual Robot Joints

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Define a Frame from actual Robot Joints

lmarkie74 Offline
Member
**
Posts: 22
Threads: 13
Joined: Apr 2021
Reputation: 0
#1
12-07-2021, 03:57 PM
I am trying to created a frame at the part on my weld fixture using a 3 point. I have included the axis positions in an excel spread sheet. They are highlighted in yellow.  Yesterday, I recorded the axis of the 6 joints and today I recorded the axis of the 6 points just to see if I have an error.  Both were no where near the coordiantes of the KUKA robot.

Can anyone tell me what I have done wrong?


Attached Files
.xlsx   Frame E1-E2 Axis Calibration.xlsx (Size: 11.31 KB / Downloads: 233)
.rdk   Robot Cell Rev8.rdk (Size: 18.32 MB / Downloads: 253)
Find
Reply
lmarkie74 Offline
Member
**
Posts: 22
Threads: 13
Joined: Apr 2021
Reputation: 0
#2
12-09-2021, 09:03 PM
(12-07-2021, 03:57 PM)lmarkie74 Wrote: I am trying to created a frame at the part on my weld fixture using a 3 point. I have included the axis positions in an excel spread sheet. They are highlighted in yellow.  Yesterday, I recorded the axis of the 6 joints and today I recorded the axis of the 6 points just to see if I have an error.  Both were no where near the coordiantes of the KUKA robot.

Can anyone tell me what I have done wrong?

I discovered, if you "Remove Sync", it works.  Can anyone explain to me Why?
Find
Reply
  




Users browsing this thread:
1 Guest(s)