Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FANUC driver issue. Uninitialized data used line 551
#1
Hello,

I followed the procedure outlined in this documentation. The whole procedure was very easy to follow and I didn't run into any issues. I started RDK_S3.pc on my FANUC R-30iB Plus controller then I booted up RoboDK on my computer and connected the computer to the controller via RoboDK. A connection was established and it said "Ready" in the connection status bar. I then tried to click on "Get Position" and my control ended the RDK_S3.pc program and threw the error:

RDK_S3 LINE 551 PAUSED
INTP-311 (RDK_S3, 551) Uninitialized data is used.

I tried again, this time selecting the "Run on robot" and "Run" options, and those too raised the same error codes. Unfortunately, it looks like a .pc program is compiled code, so I can't see what line 551 is. Does anyone have a solution to this problem?

Thank you,
-RoboSmith
#2
It looks like the robot stops when you wait for a digital input.

More precisely, this line:
Code:
UNTIL DIN[din_id] = din_state
Are you able to make the robot move?
Can you provide us with the RoboDK file and the log after it fails?
#3
Hello,

Where can I find this script that you are referring to? Is it in the RDK_S3.pc file? Because it seems to be compiled code to where I can't open it and see the lines of code.

As far as the connection log, this is all it is:

Disconnected
Stopped
Starting robot driver: C:/RoboDK/api/apirobot.exe
Starting...
Disconnected
Sending command...
Trying connection 192.168.2.2:2000...
Disconnected
Trying connection 192.168.2.2:2000...
Disconnected
Trying connection 192.168.2.2:2000...
Disconnected
...etc...

Thank you,
-RoboSmith
  




Users browsing this thread:
1 Guest(s)