Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Frames are leaving traces and wont dissappear.

#1
Essentially my problem has been explained in the title. I have this screenshot to further show my problems. The reference frames disappear if CtRL z instead of deleting them but that does not work with the traces left behind the end frame. Those come when I increase/decrease the angle of the location of the end effector. 

[Image: sogjbQ2.jpg]

Do I need to change some settings or this is a bug which can be solved by deleting and installing the program again? It is very hard to work with the traces as they can quickly block the view. Thanks. I am new to RoboDK maybe there is a setting I need to change?
#2
You have the trace activated. You can desactivate following these steps:
  1. Tool-Trace-Active (uncheck)
  2. Tool-Trace-Reset
  




Users browsing this thread:
1 Guest(s)