Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Small circles along spline when importing DXF

#1
I made a simple spline in creo and exported it as a dxf using these settings:
   

I then imported it to robodk using dxf2gcode but for some reason small circles appears along the spline:
   
   

This does not happen if I make a simple circle:
   

Does anybody know what causes these small circle and how to avoid it?


Attached Files
.rdk   spline.rdk (Size: 1.62 MB / Downloads: 510)
#2
Can you provide the DXF file?
#3
The issue was happening because I had set the machine type to "draft knife". Setting it to "milling" and the circles were gone.
  




Users browsing this thread:
1 Guest(s)