Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Using C3bridge in KRC5 controller and can't create a port "7001"

#1
Hello everyone, I am using a kuka kr4 robot arm, with KRC5 controller. I noticed that in the manual for connecting kuka robots, it says that it is for the KRC2,3,4, but I would like to connect the robot using the C3bridge. Is there a manual that I can use for a KRC5, since I am experiencing problems when adding a port "7001" in the network configuration, after restarting the controller, the creation of port "7001" is not reflected. can you help me please
#2
Try following my recommendations from your previous thread:
https://robodk.com/forum/Thread-Real-Tim...KR10-Robot

Start by trying to use port 7000.
If that doesn't work, you can change the port to any other port, such as 6999 or 7002, etc.
  




Users browsing this thread:
1 Guest(s)