[mvasquez.7]

Hello 

I have been trying to connect Robodk with Denso VP-6243G2U for online programming but the same error appears:

"Can not set to Work=WORK0
Can not set to Tool=TOOL0"

causing an Unknow status.

I have the latest version of Robodk and I have followed the instructions provided by robodk to connect with Denso robots. I believe I have edited the driver properly but when I try to connect the log shows this:(sc_error_1.png).
   

I hope you can help me.

Best regards,

Marcos Vasquez

[Sam]

Did you follow the instructions in our documentation? See https://robodk.com/doc/en/Robots-Denso.html#DriverDenso.
Are Work0 and Tool0 defined in your controller?