[farhan]

Hello,
I have project about welding with Motoman MH80. I have my own tool and already attached the end-effector of robot. The robot uses a Yaskawa Motoman DX100 controller. I want to control the tool from the controller just for like on/off. Could i do that by modifying the post-processor motoman in RoboDK? Which one i should change in the post-processor?

[Albert]

You can use an instruction to set the value of a digital output:
https://robodk.com/doc/en/Robot-Programs.html#InsIO

Are you currently using the Welding Addin? If you can provide us with the RoboDK project file we can help you better. You can find more information about the welding addin here:
https://robodk.com/addin/com.robodk.app.welding

[farhan]

okay,
i want to access welding add-in, but when I clicked the link you provided, this is showed (I attached it below). does it mean I already installed it? if yes, how could I access it?

[Sergei]

Please contact us on the following page:
https://robodk.com/contact

Alternatively, you can use Help-Request Support in RoboDK.