Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Yaskawa Motoman GP25 pulse to degree

#1
Hi.

I am a beginner of RoboDK SW, and I am trying to use yaskawa gp25.

I found that GP25 controller sends the pulse data, not joint angles, and I don't know the exact parameters to convert pulse to degree or versa. 

   

I referred to the site below but still doesn't work.

https://robodk.com/forum/Thread-Pulses-p...ee-Yaskawa

Is there any way to check the exact pulse to degree parameter of GP25 ?

And where is ALL.prm file ?

Thank you !
#2
Did you read this section of the documentation?
https://robodk.com/doc/en/Robots-Motoman.html#Motoman

Especially this sub section: https://robodk.com/doc/en/Robots-Motoman...omanPulses

Jeremy
Find useful information about RoboDK and its features by visiting our Online Documentation and by watching tutorials on our Youtube Channel


#3
(09-07-2022, 02:01 PM)Jeremy Wrote: Did you read this section of the documentation?
https://robodk.com/doc/en/Robots-Motoman.html#Motoman

Especially this sub section: https://robodk.com/doc/en/Robots-Motoman...omanPulses

Jeremy

Thanks for your reply.

I loaded GP-25 robot in RoboDK, and checked 'Robot Parameters'.

The default values of 'pulse/degree' are all '1'. 

     

What I referred the manual that you attached, the pulse/degree values are for motoman MH5F, not for GP25.

I tried to find 'ALL.PRM', but can't.

Is there any way to check the detail values of 'pulse/degree' for motoman GP25 ?
#4
(09-08-2022, 12:45 AM)swimpark Wrote:
(09-07-2022, 02:01 PM)Jeremy Wrote: Did you read this section of the documentation?
https://robodk.com/doc/en/Robots-Motoman.html#Motoman

Especially this sub section: https://robodk.com/doc/en/Robots-Motoman...omanPulses

Jeremy

Thanks for your reply.

I loaded GP-25 robot in RoboDK, and checked 'Robot Parameters'.

The default values of 'pulse/degree' are all '1'. 

 

What I referred the manual that you attached, the pulse/degree values are for motoman MH5F, not for GP25.

I tried to find 'ALL.PRM', but can't.

Is there any way to check the detail values of 'pulse/degree' for motoman GP25 ?

Apparently I cant access the parameters with the program trial so I am unable to test this myself. 

I believe the directions are saying to load the All.PRM file from your own robot backup, so step 1 would be to make that robot backup.  Then add in the GP25 from the library and drop the ALL.PRM file in.
  




Users browsing this thread:
1 Guest(s)